Der Markt; alle Pre-War fahrzeuge zu verkaufen

Enots  Brass  fuel tap  ..  ex -  1920s Morris    but probably fitted to various UK  vehicles    ..  has been stored many years  but moves freely  and is fully intact ..it may require  a new gasket   due  to the long term storage  ...      will post anywhere at cost   

Morris Commercial  0-10 psi    oil gauge   c.1920s    ... stored many years and is in   untampered   untested    condition .. Although grubby   there is no  visible damage      so should clean up well      ...   the body diameter  is circa 61mm     will post anywhere at cost    ...  

inlet and exhaust manifoldsfor PEUGEOT 12 HP 6 cylindersecond-handall informations and pictures on request

Morris Minor engine circa 1932  no 42283A complete with clutch , condition will need to be checked  € 1500

Intake manifold for two carb setup. Requires repair. 

  Clutch Gear hub   + RHP self aligning  flywheel bearing  to suit  either  1920s  Morris Bullnose  or Flatnose  Models ..These are both  new  unused   old stock   ...collection or will post at cost    

Bugatti T37/40Original Inlet Manifold complete. It has not been  in a car for over 50 years in good original condition.

Bugatti T51 Original x 2 Inlet Manifold and Joining piece  complete, with Blow Off ValveFully Machined With Ki-Gass blanking plugs53mm diameter blower flange outlet 

1920s  Morris Motors oil gauge ..approx 60mm hole fitting  ..stored   50+ years   untested and untampered  ..no visible  damage to  bezel etc should clean up  well ..complete with original  fitting bracket and brass thumb  nuts   ..collect or post at cost