A what appears to be new (NOS? there are no signs of any apparent use) 'Luxor' Acetylene rear lamp to fit a Veteran or Vintage Motorcycle.
It is almost perfect, with a couple of very small marks from a long period in storage.
I suspect that it is probably for a French (or Continental) Motorcycle from the 1920's, as I believe that this pattern of..
QTY 2 CHROME FRONT SIDE LIGHTS. UN KNOWN MANUFACTURER
3.1/2 INCH WIDE LENS. HAS A SMALL RED MARKER ON TOP SO WHEN LIGHTS ON SHINES. ALL COMPLETE. CHROME NOT BAD JUST
AT THE BACK OF SCREW CHROME SHOWING WEAR. WILL SHIP WORLD WIDE AT COST . CAN DO PAY PAL
These are the last of my collection of hinges. 3 cranked or off-set 1.5" (38mm) wide with approximately 1.25" (32mm) off-set; good condition no slack in the pins. Also 3 flat hinges which are 1.75" (44mm) wide; 1 off 7.5" (190mm) open, 1 off 6.75" (180mm) open and 1 off 6" (155mm) open. If you need further information or photos please ask
QTY 1 BOSH SIDE LIGHT MODEL J70 nr 670. NEW OLD STOCK THIS LAMP I DO NOT THINK HAS BEEN FITTED IT IS IN LOVELY CONDITION INSIDE + LENS REFLECTOR VERY GOOD.
IN GOOD CONDITION. WILL SHIP WORD WIDE AT COST. CAN DO PAY PAL
An original Eureka pressure gauge, graduated to 10 psi so would suit low oil or fuel air pressure. It has bezel diameter of 2 5/8 inches and would fit a dashboard hole of about 2 3/8 inches. Has bevelled glass, not tested. Buyer pays shipping cost.
An original early Smiths water temp gauge. It has a bezel diameter 2.25 inches and would fit a dashboard hole of 2 inches. Gauge is in excellent cosmetic condition but is missing the sender bulb so will require refurbishment. Chrome bezel very good as is the black dial. Buyer pays shipping costs.
"The K3 Magnette must rank in the history books as the most famous and successful of all the record breaking MGs. With only 33 examples produced durin..