Der Markt; alle Pre-War fahrzeuge zu verkaufen

Tyre lever for small car or motor cycle by Terry. approximately 140mm (5.5") long; good condition.I have PayPal and will post world wide

This is a Kinsman tire pump made in Shirley Birmingham these were used on some Rolls Royce cars and the 1936 - 40 MGTB and MGTA. this one is in its original box an although not brand new it is in very good condition. it also includes the original tire gauge which is rarely seen.

An original set of feeler gauges for a Rolls-Royce 25/30 toolkit. Marked ROLLS-ROYCE LTD on one side and 25/30 HP CHASSIS on the other. It has 4 feelers and one has tip missing, all feelers are marked. Buyer pays shipping costs.

Pre 1914 Renault hubcap wrench.....Renault open end wrench 17 and 21 for fine adjustments on magnetos and fine watches...........

An original new old stock Bosch distributor cap suitable for 6c 2300 and 6c 2500 Alfa Romeo

set CYLINDER RIDGE REAMERS. One: ±37-85mm The other: ±62-100mm US made. Complete, ready to use. The smaller shows the rear side, the knife is at the opposite side. If you are a friend of Castor oil, this tool is also handy to remove that hard coal rim, at the same time smoothen the wall. Please see my other ads too.

Rev Counter (Tachometre) for Alfa Romeo and other Italian Cars. RPM written as GIRI, which is Italian for Revs. NOS or New

Modern BRITOOL torque wrench 1/2". Hardly used. For specs. please see photo. Made in UK. (new: euro 215,00)

Nice original Lucas inspection lamp as used on Rolls-Royce & Bentley cars from the 20s to the 50s. Lots of patina, or, in other words, very little plating left on it. Could probably do with rewiring.

I have owned this fabulous original model of a 1932 Alfa Romeo P2 for almost 40 years. It has been housed in a glass case in my office. As you can see, the paint is original, and the front engine strap made of leather has broken. The car is 20 inches long and has clockwork movement. I believe it is a CIJ but no marking can be found. The sale wi..