Der Markt; alle Pre-War fahrzeuge zu verkaufen

This manually operated horn is in excellent condition and ready to bolt onto your brass era or later car. Manufactured by G.Piel & Co. of L.I City, NY, the manufacturers plate shows patents from 1910 and 1911. It is fully functioning and sounds, er, great. The trumpet has a small (20mm) crack in the rim but is otherwise fine. It is around 22cm ..

very beautiful Cicca horn, in working order. 6 volts

ROBERT BOSCH HORN MODEL  U1A  12 VOLT IN VERY GOOD CONDITION          WORKING       VERY LOUD WILL SHIP WORLD WIDE CAN DO PAY PAL

Horn of unknown make, most likely 12 Volts

1 Tenor cicca horn, 12 volts

Original Bosch FD6A 6 volt motorcycle horn. These were used from the late 20's, through the 1930's. It works well and is very loud. The mount has slight damage but is repairable. The rest is OK, and still has most of its original paint, and the mesh and brass badge are still intact. I can post this, and I accept PayPal.

Original Bosch FD6A 6 volt motorcycle horn. These were used from the late 20's, through the 1930's. It works well and is very loud. The trumpet-part has a slight dent, however, this is repairable. The rest is OK, and still has most of its original paint, and the mesh and brass badge are still intact. I can post this, and I accept PayPal.

Four flute horn missing two flutes needing restoration.  This horn would restore into an excellent and most attractive horn as the sound from the two intact flutes is wonderful. Overall length 43 Cms.  Largest diameter flute is 6 Cms.  A similar but unmatched brass flute will be included in the sale. Additional photos on request.

Triple flute horn has great patina and is stamped 'Made in Germany' on the smallest flute.  Excellent sound and comes with a 10 Cms diameter rubber bulb which is in good condition.    Overall horn length is 34 Cms with the largest flute mouth diameter 5 Cms and smallest 3.5 Cms.  Bulb length is 15 Cms.  More photos on request.

Motorcycle horn, make "Cicca", Paris. Probably from the 1930s. The unit is fixed to the motorcycle fame end a cable needs to be pulled so that the rubber drive wheel engages against the motorcycle tyre.  Appears to be mechanically complete but I have not had it installed on a motorcycle so I have not been able to verify that it works...