Der Markt; alle Pre-War fahrzeuge zu verkaufen

A set of the four special, Plated, Raised Countersunk 1/4" x 1/2" BSF sets that held the instrument panel in place on 'Ulsters' and, possibly, other Austin 7 cars.These are very old stock, but in reasonable condition. I once had a large stock  and found these few in the proverbial tobacco tin ! I have a couple of sets only. As far..

A N.O.S. head and exhaust manifold gasket set for an Austin 7. The head gasket is of the High Compression type.There is very slight damage, just beyond the final stud hole, to one end of the exhaust gasket. This is visible in the photo. This is very old stock, so please be aware it may possible be a Copper/Asbestos composite. However, i cannot b..

Austin 7, engine front timing gear which fits on the nose of the crankshaft. These are original Austin parts. They have no '+' or '-' markings so must be considered to be for a within tolerances assembly. However, in my experience, timing gear pairs are best matched by fitting as a pair, regardless of marks and measuring the backlash unti..

A set of very old stock Austin 7 sump retaining bolts. They have the special deep head and are threaded 1/4" B.S.W. Please also note that there are probably cadmium plated as original and should be handled with care as I understand that cadmium may be harmful if ingested! There are 14 bolts in the set.As the item is ..

A very old Austin 7 flywheel puller. I have owned this for some 50 years and it is quite possible that this is an original Austin manufactured tool. It has been used and does exhibit usage marks. It is in good, usable condition. The end of the large central bolt is shaped to locate into the small indent on the end of the crankshaft.

Original Austin 7 valve spring compressing tool. It is in good condition, though must have been used at some point in the past ! As the item is in France it is priced in €'s. Postage, packing and insurance (if requested) will be extra and charges at cost.

Bosch HABS9 ignition switch in lovely original condition. This is the correct ignition switch for Alfa Romeo 8c or 6c. 

NOS Twin Ignition Pointset Doduco 661 to fit -Adler mc M200 Noris ign.-Bastert B/M 2-125-Condor 350 ccm 2-cyl.-Express Radex 252 (ILO 2-125)-Gutbrod van 604/Atlas 800 & 1000-Hecker K-250Z-Hummel-Roller Sport 250-Rabeneick F 250/2-UT TS-252-Vögele Mannheim-Wendax WS400Plus several others.

A nice very early brass era master vibrator made by New York Coil Co. Bat-Off-Mag. 6" by 3" by 3".   In  very nice original condition and complete. Great brass switch. Price is 185.00 USD plus shipping.  Call at 734-730-4274 or email [email protected]  for more photos or information. Thanks. 

Complete Bosch HAB4 ignition switch, lovely condition. This is a different version without the chrome bezel, compared to the other advertised. Push button lever and key positions are not stuck. Original key included.