Der Markt; alle Pre-War fahrzeuge zu verkaufen

A set of the four special, Plated, Raised Countersunk 1/4" x 1/2" BSF sets that held the instrument panel in place on 'Ulsters' and, possibly, other Austin 7 cars.These are very old stock, but in reasonable condition. I once had a large stock  and found these few in the proverbial tobacco tin ! I have a couple of sets only. As far..

for unknown car85 euros plus shipping

A N.O.S. head and exhaust manifold gasket set for an Austin 7. The head gasket is of the High Compression type.There is very slight damage, just beyond the final stud hole, to one end of the exhaust gasket. This is visible in the photo. This is very old stock, so please be aware it may possible be a Copper/Asbestos composite. However, i cannot b..

Austin 7, engine front timing gear which fits on the nose of the crankshaft. These are original Austin parts. They have no '+' or '-' markings so must be considered to be for a within tolerances assembly. However, in my experience, timing gear pairs are best matched by fitting as a pair, regardless of marks and measuring the backlash unti..

A set of very old stock Austin 7 sump retaining bolts. They have the special deep head and are threaded 1/4" B.S.W. Please also note that there are probably cadmium plated as original and should be handled with care as I understand that cadmium may be harmful if ingested! There are 14 bolts in the set.As the item is ..

A very old Austin 7 flywheel puller. I have owned this for some 50 years and it is quite possible that this is an original Austin manufactured tool. It has been used and does exhibit usage marks. It is in good, usable condition. The end of the large central bolt is shaped to locate into the small indent on the end of the crankshaft.

Original Austin 7 valve spring compressing tool. It is in good condition, though must have been used at some point in the past ! As the item is in France it is priced in €'s. Postage, packing and insurance (if requested) will be extra and charges at cost.

An original ODA fuel tap measuring about 65 mm tall and 50 mm wide.  Exactly the same as the one fitted to my Type 43 Bug.  Fully marked ODA and in very good original condition.  Buyer pays shipping cost.